From: Nordhoff, Michael G. (US - Hermitage) (mnordhoff@deloitte.com)
Date: Wed Dec 04 2002 - 13:02:50 GMT-3
Nathan,
My understanding is you don't need the 'frame-relay fragment' command when
you use the 'vofr cisco' command because the 'vofr cisco' command
automatically gives you fragementation.
You would only need the 'frame-relay fragment' command when you are
configuring FRF.11 or FRF.12 fragementation as part of your traffic shaping
map-class.
The 'vofr data {cid}' command is only used when you want to change the data
subchannel from the default value of 4. You shouldn't need to do this.
HTH...
- MN
-----Original Message-----
From: Nathan Chessin [mailto:nchessin@cisco.com]
Sent: Tuesday, December 03, 2002 10:39 PM
To: ccielab@groupstudy.com
Subject: VoFR
Hi All,
I know that when we configure VoFR there are a few commands we need.
frame-relay traffic-shaping (main interface)
frame-relay interface-dlci 104
vofr cisco
class voice
map-class frame-relay voice
frame-relay voice bandwidth X
Caslow says that this will only support a voice over frame dlci and not
data.
Do we need to have a fragment X command in there also? And what is the
purpose of the
vofr data command under the interface-dlci?
Thanks in advance,
Nate
- This message (including any attachments) contains confidential information
intended for a specific individual and purpose, and is protected by law. -
If you are not the intended recipient, you should delete this message and
are hereby notified that any disclosure, copying, or distribution of this
message, or the taking of any action based on it, is strictly prohibited.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:38 GMT-3