From: Sam.MicroGate@usa.telekom.de
Date: Tue Nov 26 2002 - 13:54:59 GMT-3
Hello Group,
I am having a problem configuring multicast network over frame relay. I
configured a hup and spoke topology. The hup is RP and the mapping agent in
the same time. All the interfaces in the hup and the spokes are configured
with ip pim sparse-mode. The phasycal and multipoint interfaces have ip pim
nbma-mode configured. One of the ethernet interfaces is configured to join
233.0.0.1 group. Here is the result of ping 233.1.1.1 and show ip mroute
from the other spoke. Is it normal for ping to reply with the line below
instead of the !!!!!? Also why the flag of (150.50.7.6, 233.0.0.1) is
registering?
r6#ping 233.0.0.1
Type escape sequence to abort.
Sending 1, 100-byte ICMP Echos to 233.0.0.1, timeout is 2 seconds:
Reply to request 0 from 150.50.100.5, 148 ms
Reply to request 0 from 150.50.100.5, 172 ms
r6#
r6#sh ip pim rp
Group: 233.0.0.1, RP: 200.0.0.2, v2, v1, uptime 00:02:20, expires 00:02:41
r6#
r6#sh ip mroute 233.0.0.1
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned
R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT
M - MSDP created entry, X - Proxy Join Timer Running
A - Candidate for MSDP Advertisement
Outgoing interface flags: H - Hardware switched
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
(*, 233.0.0.1), 00:05:20/00:02:58, RP 200.0.0.2, flags: SPF
Incoming interface: Serial0, RPF nbr 150.50.100.2
Outgoing interface list: Null
(150.50.7.6, 233.0.0.1), 00:00:43/00:02:16, flags: FT
Incoming interface: Ethernet0, RPF nbr 0.0.0.0, Registering
Outgoing interface list:
Serial0, 150.50.100.2, Forward/Sparse, 00:00:42/00:02:47
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:23:11 GMT-3