RE: How to change distance for some ex eigrp route

From: Robert Massiache (robert2140@hotmail.com)
Date: Tue Nov 19 2002 - 18:19:26 GMT-3


thanks a lot Scott!

>From: "Scott Livingston" <scottl@sprinthosting.net>
>To: "'Kumar, Senthil'" <senthil.kumar@intechnology.co.uk>, "'Sara Li'"
><saralilin@hotmail.com>, <donny.mateo@sg.ca-indosuez.com>,
><robert2140@hotmail.com>
>CC: <ccielab@groupstudy.com>
>Subject: RE: How to change distance for some ex eigrp route
>Date: Tue, 19 Nov 2002 09:55:38 -0600
>
>########################################################################
>####
>http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/
>ip_r/iprprt2/1rdeigrp.htm#xtocid5
>Note You cannot set the administrative distance in EIGRP against
>certain routes or sources, as you can with other protocols. The command
>does not work this way with EIGRP.
>########################################################################
>####
>
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
>Kumar, Senthil
>Sent: Tuesday, November 19, 2002 4:20 AM
>To: Sara Li; donny.mateo@sg.ca-indosuez.com; robert2140@hotmail.com
>Cc: ccielab@groupstudy.com
>Subject: RE: How to change distance for some ex eigrp route
>
>distance command for host/network specific routes doesnt work in eigrp
>the
>same way it does with ospf and isis. you can change it as a whole else
>use
>distribute lits.
>
>
>-----Original Message-----
>From: Sara Li [mailto:saralilin@hotmail.com]
>Sent: 19 November 2002 07:38
>To: donny.mateo@sg.ca-indosuez.com; robert2140@hotmail.com
>Cc: ccielab@groupstudy.com
>Subject: Re: How to change distance for some ex eigrp route
>
>
>why not try this under router eigrp
>
>distance 0.0.0.0 255.255.255.255 1--->acl
>
>access-list 1 permit <network>
>
>
>
> >From: "Donny MATEO" >Reply-To: "Donny MATEO" >To: "Robert Massiache"
> >CC: ccielab@groupstudy.com >Subject: Re: How to change distance for
>some
>ex eigrp route >Date: Tue, 19 Nov 2002 13:52:39 +0800 > >the original
>question was for a specific route. > >there are two command for distance
>under the router configuration mode >The first one is based on ACL <
>distance xxx src mask acl-num> >the second one is based on the routing
>protocol < distance eigrp|ospf|bgp> > >only the first one can be use for
>selective route, but as the original poster indicated it does not
> >effect
>external route. So the question is whether it is possible to change the
>distance of >"particular" external route and if yes by what command ? >
> >Your solution would change the distance of all eigrp internal route to
>100 and all eigrp external >(redistributed) route into 200. Now if you
>would like to modify only particular route,, how do you >do that ? >
> >Donny > > > > "Robert > Massiache" To: donny.mateo@sg.ca-indosuez.com >
> > il.com> Subject: Re: How to change distance for some ex eigrp route >
> >
>19-11-2002 12:59 > > > > > > >You don't even need the rotue-map. I used
>it for OSPF so I thought there >would be a similar way for EIGRP too. >
> >R4(config-router)#distance eigrp ? > <1-255> Distance for internal
>routes >R4(config-router)#distance eigrp 100 ? > <1-255> Distance for
>external routes >R4(config-router)#distance eigrp 100 200 ? >
> >R4(config-router)#distance eigrp 100 200 > > >thanks >Robert M > > > >
> >
> > > > >From: "Donny MATEO" > >Reply-To: "Donny MATEO" > >To: "Robert
>Massiache" > >CC: ccielab@groupstudy.com > >Subject: Re: How to change
>distance for some ex eigrp route > >Date: Tue, 19 Nov 2002 11:26:06
>+0800
> > > > >Can't seems to find the command for that one under router eigrp.
> >
> >What IOS version are you using ? > > > > > > > > > > "Robert > >
>Massiache" To: > >guoqicui@yahoo.com, ccielab@groupstudy.com > > > >
>il.com> Subject: Re: How to change > >distance for some ex eigrp route >
> > Sent by: > > nobody@groupstudy > > .com > > > > > > 19-11-2002 10:43 >
> > Please respond to > > "Robert > > Massiache" > > > > > > > > > > > > >
> >use the route-map instead. You got the option of matching external
>routes > >alone. ITs avalable for bgp, ospf and as well as eigrp. > > >
> >Just call the route-map from the distance command. I never tried for
>eigrp > >but I know it works fine for OSPF E2 routes. > > > >thanks > >
> >
> > > > > > > > > > >From: Guoqi Cui > > >Reply-To: Guoqi Cui > > >To:
>ccielab@groupstudy.com > > >Subject: How to change distance for some ex
>eigrp route > > >Date: Mon, 18 Nov 2002 16:44:31 -0800 (PST) > > > > >
> >Hi, group: > > >Is there a way to change the adminstrative distance > >
> >of some selected "EX D" eigrp routes. > > > > > >I tried: > > >distance
>100 x.x.x.x y.y.y.y acc-num > > > > > >This command only change the
>distance of routes with > > >tag "D". There is no effect for "D Ex"
>routes. > > > > > >distance eigrp 100 100 > > > > > >will change the
>distance of all routes. > > > > > >what I need is a way to change only
>the distance of a > > >selected routes. > > > > > >Thank you. > > > > >
> >Guoqi > > > > > > > >
> >__________________________________________________ > > >Do you Yahoo!?
> >
> > >Yahoo! Web Hosting - Let the expert host your site > >
> >http://webhosting.yahoo.com > > > > >
> >_________________________________________________________________ >
> >Tired of spam? Get advanced junk mail protection with MSN 8. >
> >http://join.msn.com/?page=features/junkmail > > > > > > > > > > > >This
>message is for information purposes only and its content > >should not
>be
>construed as an offer, or solicitation of an offer, > >to buy or sell
>any
>banking or financial instruments or services > >and no representation or
>warranty is given in respect of its > >accuracy, completeness or
>fairness. The material is subject > >to change without notice. You
>should
>take your own independent > >tax, legal and other professional advice in
>respect of the content > >of this message. This message may contain
>confidential or > >legally privileged material and may not be copied,
>redistributed > >or published (in whole or in part) without our prior
>written consent. > >This email may have been intercepted, partially
>destroyed, > >arrive late, incomplete or contain viruses and no
>liability
>is > >accepted by any member of the Credit Agricole Indosuez group > >as
>a result. If you are not the intended recipient of this message, >
> >please immediately notify the sender and delete this message > >from
>your computer. > >
> >_________________________________________________________________ >MSN
>8
>helps eliminate e-mail viruses. Get 2 months FREE*.
> >http://join.msn.com/?page=features/virus > > > > > > >This message is
>for information purposes only and its content >should not be construed
>as
>an offer, or solicitation of an offer, >to buy or sell any banking or
>financial instruments or services >and no representation or warranty is
>given in respect of its >accuracy, completeness or fairness. The
>material
>is subject >to change without notice. You should take your own
>independent >tax, legal and other professional advice in respect of the
>content >of this message. This message may contain confidential or
> >legally privileged material and may not be copied, redistributed >or
>published (in whole or in part) without our prior written consent. >This
>email may have been intercepted, partially destroyed, >arrive late,
>incomplete or contain viruses and no liability is >accepted by any
>member
>of the Credit Agricole Indosuez group >as a result. If you are not the
>intended recipient of this message, >please immediately notify the
>sender
>and delete this message >from your computer.
>
>------------------------------------------------------------------------
>
>MSN 8 helps ELIMINATE E-MAIL VIRUSES. Get 2 months FREE*.
>
>________________________________________________________________________
>This message has been checked for all known viruses by the
>CitC Virus Scanning Service powered by SkyLabs. For further information
>visit
>http://www.citc.it
>
>___
>
>________________________________________________________________________
>This message has been checked for all known viruses by the
>CitC Virus Scanning Service powered by SkyLabs. For further information
>visit
>http://www.citc.it



This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:23:07 GMT-3