From: Jennifer Bellucci (Jennifer_bellucci@hotmail.com)
Date: Mon Nov 18 2002 - 20:03:22 GMT-3
I have configured the following:
r13----cat3550---r14
The config is provided below. On r14, the router is learning the route
50.50.50.0 and 60.60.60.0 through BGP and is in routing table, but I am unable
to ping it.
The CAT3550 can ping the loopbacks.
Can you please have a look at the config and let me know what I am doing
wrong.
R14
!
interface FastEthernet0/0
ip address 131.108.171.14 255.255.255.224
duplex auto
speed auto
!
!
router bgp 400
no synchronization
bgp router-id 131.108.171.14
bgp log-neighbor-changes
neighbor 131.108.171.10 remote-as 300
no auto-summary
!
R13
!
!
interface Loopback0
ip address 50.50.50.1 255.255.255.0
!
interface Loopback1
ip address 60.60.60.1 255.255.255.0
!
interface Ethernet1/0
ip address 100.100.100.13 255.255.255.0
half-duplex
!
router eigrp 100
network 50.50.50.0 0.0.0.255
network 60.60.60.0 0.0.0.255
network 100.100.100.0 0.0.0.255
no auto-summary
no eigrp log-neighbor-changes
!
router bgp 300
no synchronization
bgp router-id 100.100.100.13
bgp cluster-id 1010580481
bgp log-neighbor-changes
redistribute eigrp 100 metric 50
neighbor 100.100.100.10 remote-as 300
neighbor 100.100.100.10 route-reflector-client
no auto-summary
!
CAT3550
!
interface FastEthernet0/14
no switchport
ip address 131.108.171.10 255.255.255.224
no ip split-horizon
!
interface FastEthernet0/23
no switchport
ip address 100.100.100.10 255.255.255.0
no ip split-horizon
!
router eigrp 100
network 100.100.100.0 0.0.0.255
distribute-list 1 in
auto-summary
no eigrp log-neighbor-changes
!
router bgp 300
no synchronization
bgp router-id 100.100.100.10
bgp log-neighbor-changes
neighbor 100.100.100.13 remote-as 300
neighbor 131.108.171.14 remote-as 400
no auto-summary
!
access-list 1 deny any log
route-map eigrpdeny permit 10
match ip address 1
!
r14-3640#I
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter
area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is not set
50.0.0.0/24 is subnetted, 1 subnets
B 50.50.50.0 [20/0] via 131.108.171.10, 00:10:47
100.0.0.0/24 is subnetted, 1 subnets
B 100.100.100.0 [20/0] via 131.108.171.10, 00:10:47
10.0.0.0/24 is subnetted, 1 subnets
C 10.10.10.0 is directly connected, ATM2/0
131.108.0.0/27 is subnetted, 1 subnets
C 131.108.171.0 is directly connected, FastEthernet0/0
121.0.0.0/24 is subnetted, 2 subnets
C 121.121.121.0 is directly connected, Loopback0
C 121.121.122.0 is directly connected, Loopback1
60.0.0.0/24 is subnetted, 1 subnets
B 60.60.60.0 [20/0] via 131.108.171.10, 00:10:48
r14-3640#ping 50.50.50.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 50.50.50.1, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
Jennifer Bellucci
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:23:05 GMT-3