From: Gary Lileikis (glileikis@rogers.com)
Date: Sun Nov 17 2002 - 21:12:44 GMT-3
I believe this will work. Make sure the new loopback interface in in the
routing process and it's network number is know by other routers.
Interface Ethernet 0
ip nat inside
ip address 10.0.0.1 255.255.255.0
!
!
Int loop 0
Ip address 192.168.3.1 255.255.255.0
!
Interface Serial 0
ip nat outside
ip address 192.68.1.1 255.255.255.0
!
Interface Serial 1
ip nat outside
ip address 192.68.2.1 255.255.255.0
!
ip nat inside source list 1 interface loop 0 overload
!
!
access-list 1 permit 10.0.0.0 0.0.0.255
Regards,
Gary Lileikis
-----Original Message-----
From: Nate Kleven [mailto:cciemail@intellinet.ws]
Sent: Sunday, November 17, 2002 2:47 AM
To: ccielab@groupstudy.com
Subject: NAT To Multiple Outside Interfaces
There is probably a very easy solution to this, but it escapes me:
Router
1 has three interfaces, 1 ethernet and 2 serials. The ethernet is the
NAT INSIDE interface. Clients on the inside need to be NAT'd for
request going out both of the serial interfaces. How do I do this?
Normally it would look something like this.
Interface Ethernet 0
ip nat inside
ip address 10.0.0.1 255.255.255.0
!
!
!
Interface Serial 0
ip nat outside
ip address 192.68.1.1 255.255.255.0
!
Interface Serial 1
ip nat outside
ip address 192.68.2.1 255.255.255.0
!
ip nat inside source list 1 interface s0 overload
!
!
access-list 1 permit 10.0.0.0 0.0.0.255
In a configuration like this, my traffic would all go out Serial O
because it is the one in the overload statement, right? What if I want
to NAT a packet that is only reachable via serial 1? I'm sure I'm
overlooking the obvious.
Thanks in advance.
Nate
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:23:03 GMT-3