From: study@6colabs.com
Date: Thu Nov 14 2002 - 21:44:54 GMT-3
Nate,
Receiving the prefix from the ATM switch only means that ILMI works but
this is not sufficient.
You need to issue the commands "show atm vc" or "show atm pvc" and check if
you receive the PVC information that you need.
Thanks,
Fabrice Bobes
http://www.6colabs.com
Original Message:
-----------------
From: Nate Kleven cciemail@intellinet.ws
Date: Thu, 14 Nov 2002 15:07:25 -0800
To: ccielab@groupstudy.com
Subject: ATM ILMI-PVC-AUTODISCOVERY
I am trying to use the ATM ILMI-PVC-AUTODISCOVERY command in a rack that I
am renting and I can't tell if I am doing it right or not.
R7(config-if)#pvc 0/16 ilmi
R7(config-if-atm-vc)#exit
R7(config-if)#atm ilmi-pvc-discovery
R7(config-if)#exit
R7(config)#int atm1/0
R7(config-if)#ip address 120.20.70.4 255.255.255.0
1d01h: %LANE-6-INFO: ATM1/0: ILMI prefix add event received
Based on the fact that I got the system message "ILMI prefix add event
received" should I assume that it worked? Is there any other way for me to
verify?
Thanks in advance.
Nate
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:23:00 GMT-3