From: Sam.MicroGate@usa.telekom.de
Date: Wed Oct 30 2002 - 11:12:13 GMT-3
1- There is no command in EIGRP that would inform you about the hello or
hold times. However, if you issue the command sh ip EIGRP nei several times,
you can figure out this times by monitoring the time this neighbor to be
dead.
2- Unlike OSPF adjacency, the EIGRP timers do not have to be same between
neighbors.
Sam
-----Original Message-----
From: alee@cccis.com [mailto:alee@cccis.com]
Sent: Tuesday, October 29, 2002 11:11 PM
To: ccielab@groupstudy.com
Subject: questions about EIGRP
I don't know if someone has asked the following questions before.
1. I have configured a sub-interface to different hello interval such as 20
and hold time as 60 in EIGRP. Which command will show the hello interval
and hold time values? In OSPF, the command "show ip ospf int" will do it.
But I didn't find such command in EIGRP.
2. I have configured point to point routers in EIGRP. After I change the
hello interval and hold time value on just one router, which means both
routers should use different hello-interval and hold-time values, then why
both still showing neighbors when I do "show ip eigrp nei"? If I remember
correct, in OSPF if hello interval doesn't match, then both routers won't
form adjacency. Correct me if I am wrong.
Arthur Lee
Senior Network Engineer
CCC Information Services
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:59 GMT-3