From: Brian Dennis (brian@5g.net)
Date: Tue Oct 29 2002 - 20:33:34 GMT-3
The neighbor command is only needed on the hub router. Also be sure to
set the spoke router's OSPF priority to 0 also.
Brian Dennis, CCIE #2210 (R&S/ISP Dial)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Benny Chong
Sent: Tuesday, October 29, 2002 2:35 PM
To: ccielab@groupstudy.com
Subject: neighbor in a frame relay Multipoint network
Hi,
I am configuring OSPF In a simple frame relay hub and spoke multipoint
topology, with R1 as the hub and R2 and R3 as the spoke. After I
configure
the ospf process in R2 and R3 with the neighbor command to R1, and
before I
configure the neighbor command to R2 and R3 on R1, R1 already form the
adjacency with R2 and R3, so i didn't have to configure the neighbor
command? Is this normal??? Because I think i need to configure the
neighbor command in all routers in a multipoint FR network in order for
it
to work properly. Any idea?
Thanks!
Benny
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:59 GMT-3