From: CCIE5591 (ccie@optonline.net)
Date: Sun Oct 27 2002 - 22:13:54 GMT-3
Long ago, I had the same problem and the only way around was to put clocking
on the other side. I know that could be a problem, especially, if you
already have a cable that has DCE on the AGS end:-(
BTW, I switched the jumper and that did not work for me either.
Switching the cable worked for my AGS+.
Manjeet Chawla
mchawla@optonline.net
CCIE #5591
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Peng Zheng
Sent: Sunday, October 27, 2002 3:33 PM
To: ccie@dg4acr.org
Cc: ccielab@groupstudy.com
Subject: Re: Setting clock rate for DTE's is not allowed
I set up W51 and W41 according to:
http://www.cisco.com/univercd/cc/td/doc/product/core/cisagspl/agscfig/21594.
htm#xtocid174907
But it didn't work. The same error I got.
DOes anyone know why?
--- ccie@dg4acr.org wrote:
> Hi,
>
> there are Jumpers on the Interface Cards you have to
> set them to DCE
> Search the Doc CD with the following keywords
>
> AGS Hardware Installation
>
> If u set them it will work fine
>
> cu
>
> Knut
>
> Peng Zheng <zpnist@yahoo.com> schrieb am 27.10.2002,
> 19:06:50:
> > When I set up the clock rate for AGS router ( I
> want
> > it to be a frame-relay switch), after I set up:
> >
> > no ip address
> > encapsulation frame-relay
> > frame-relay lmi-type ansi
> > frame-relay intf-type dce
> >
> > I type :
> > clock rate 64000, then I got:
> > Setting clock rate for DTE's is not allowed
> >
> > Does anyone know what't the problem?
> >
> > Thank you for help.
> >
> > Best Wishes,
> > Peng Zheng
> >
> > __________________________________________________
> > Do you Yahoo!?
> > Y! Web Hosting - Let the expert host your web site
> > http://webhosting.yahoo.com/
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:57 GMT-3