From: Ibrahim (ibrahim@sisindosat.co.id)
Date: Fri Oct 25 2002 - 00:05:32 GMT-3
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Just read this message, is the timeout on the dlsw remote-peer command
same meaning with "linger" in dlsw+ backup-peer command ?
Ibrahim
- -----Original Message-----
From: Voss, David [mailto:dvoss@heidrick.com]
Sent: Sunday, September 22, 2002 10:40 PM
To: ccielab@groupstudy.com
Subject: RE: DLSW and backup over ISDN
For DLSW to work over ISDN, you must configure the following:
R1
dlsw local-peer peer-id 150.1.1.1 keepalive 0
dlsw remote-peer 0 tcp 150.1.2.2 timeout 300
R2
dlsw local-peer peer-id 150.1.2.2 keepalive 0
dlsw remote-peer 0 tcp 150.1.1.1 timeout 300
Because DLSw keepalives and data are passed on the same port tcp 2065 we
cannot filter keepalives without tearing down the circuit. The commands
above will show that the circuit is in a CONNECTED state without the
requirement of keepalives.
-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 7.0.3 for non-commercial use <http://www.pgp.com>
iQA/AwUBPbi1CfdNbkULxYdTEQKqAgCdGVo0uTWD4CV6aHJ/ZQbOT+XNbikAoKBv
lH3jlf9TymIHJBmlMot/xtyH
=7TuU
-----END PGP SIGNATURE-----
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:56 GMT-3