From: aansar@sscomp.com.sg
Date: Wed Oct 23 2002 - 22:59:09 GMT-3
jay in the hub router what should be fram relay interface (point to point
or multi point)
i did as what u said , but i used multi point fram relay interface in the
hub and left the spoke just with plain serial interface and used neighbor
in the hub router ..
what is it possible to configure (what i asked)
point to point fram relay interface in hub , and plian serial interface
in the spoke with modifying the spoke hello timer to match hub .. is it
possible,
in this configuration , as i told there is no problem of becoming
adjacent. no debug shows any problem anywhere.. pls advice
thanks
aa
"Jay" <ccienxtyear@hotmail.com>
10/24/2002 09:53 AM
To: <aansar@sscomp.com.sg>
cc: <aansar@sscomp.com.sg>, <ccielab@groupstudy.com>
Subject: Re: Adv Router is not-reachable
On your hub router, under the serial interface, type " ip ospf priority
200" and under the ospf process, specify the spoke as the neighbor
"neighbor x.x.x.x" and on the spoke serial interface, type "ip ospf
priority 0" . You could also specify on the Hub when configuring the
neighbor, such as this " neighbor x.x.x.x priority 0 " If you do this on
the Hub, then don't specify "ip ospf priority 0" under the serial
interface on the Spoke router.
thanks,
Jay
----- Original Message -----
From: aansar@sscomp.com.sg
To: Jay
Cc: aansar@sscomp.com.sg ; ccielab@groupstudy.com
Sent: Wednesday, October 23, 2002 6:38 PM
Subject: Re: Adv Router is not-reachable
the condition is, should not use any IP OSPF NETWORK commands. then how
jay
"Jay" <ccienxtyear@hotmail.com>
10/24/2002 09:38 AM
To: <aansar@sscomp.com.sg>, <ccielab@groupstudy.com>
cc:
Subject: Re: Adv Router is not-reachable
configure under the serial interfaces "ip ospf network broadcast"
-Jay
----- Original Message -----
From: <aansar@sscomp.com.sg>
To: <ccielab@groupstudy.com>
Sent: Wednesday, October 23, 2002 6:01 PM
Subject: Adv Router is not-reachable
> sh ip os data router , shows
> Adv Router is not-reachable
> but adjutancy has been established already .. what could be the problem.
>
> R1
> has point to point frame relay interface towards R2
>
> R2
> normal plain serial interface (initially hello mis matches , i changed
> hello interval of R2 )
>
> Adancy has been estabilised , no problem
> but R2 routes are not visible in R1, (sh ip os data router , shows all
the
> LSA of R2 but the first line tells adv router is not reachable)
>
> Adv Router is not-reachable
> LS age: 1625
> Options: (No TOS-capability, DC)
> LS Type: Router Links
> Link State ID: 7.7.7.7
> Advertising Router: 7.7.7.7
> LS Seq Number: 80000005
> Checksum: 0xF048
> Length: 156
> Number of Links: 11
>
> thanks
> aa
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:55 GMT-3