RE: Frame Relay back-to-back on T1 CSU/DSU module

From: MOLINA, MARTIN J (PBI) (mm1343@sbc.com)
Date: Thu Oct 17 2002 - 20:10:21 GMT-3

• Next message: Richard Davidson: "bgp bestpath med missing-as-worst :-("
• Previous message: Peng Zheng: "RE: Solutions for CCIE Practical Studies Volume I"
• Maybe in reply to: Sam Munzani: "Frame Relay back-to-back on T1 CSU/DSU module"
• Next in thread: Peter: "Re: Frame Relay back-to-back on T1 CSU/DSU module"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I believe configuring one of the routers with "frame-relay switching" and
specifying that routers' interface as "frame-relay intf-type dce" should do
the trick. I'm not sure if you have to use the same dlci on both sides or
not. The same mapping rules apply to this configuration. Good luck

-----Original Message-----
From: Sam Munzani [mailto:sam@zealtron.com]
Sent: Thursday, October 17, 2002 2:16 PM
To: ccielab@groupstudy.com
Subject: Frame Relay back-to-back on T1 CSU/DSU module

Hi,

How can you do Frame Relay encapsulation back to back with 2 routers(T1
CSU/DSU modules with T1 cross over cable)?

Any suggestions? I want to do 2 circuits just like this and bundle them
using
FRF.16

Thanks,
Sam Munzani
CCIE # 6479 (R&S)

• Next message: Richard Davidson: "bgp bestpath med missing-as-worst :-("
• Previous message: Peng Zheng: "RE: Solutions for CCIE Practical Studies Volume I"
• Maybe in reply to: Sam Munzani: "Frame Relay back-to-back on T1 CSU/DSU module"
• Next in thread: Peter: "Re: Frame Relay back-to-back on T1 CSU/DSU module"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:50 GMT-3