From: Ronny Jonathan (rjonathan@hotpop.com)
Date: Thu Oct 17 2002 - 12:47:26 GMT-3
or you can use privilege level 15 under line vty if accessing through telnet
and privilege level 15 underl line console if accessing through console
regards,
Ronny
----- Original Message -----
From: "Warner, Thomas S" <thomas.s.warner@lmco.com>
To: "'Fan Shan'" <fanshan@btamail.net.cn>; <ccielab@groupstudy.com>
Sent: Thursday, October 17, 2002 9:30 PM
Subject: RE: When I try to enable, it says "no password set"?
> When you access the router remotely and you do not have an "enable secret"
> or "enable password" configured you will not be able to enter privileged
> mode. Configure an enable password or secret and you should be fine.
>
> Tom Warner
> CCIE #10402
>
> -----Original Message-----
> From: Fan Shan [mailto:fanshan@btamail.net.cn]
> Sent: Thursday, October 17, 2002 9:03 AM
> To: ccielab@groupstudy.com
> Subject: When I try to enable, it says "no password set"?
>
>
> I didn't set enable password, when I try to enable, it.says "no passwored
> set",maybe because I had configured tunnel, how can I deal with this ?
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:49 GMT-3