From: syv (syv@911networks.com)
Date: Tue Oct 15 2002 - 19:39:22 GMT-3
On Tuesday, October 15, 2002, MADMAN wrote:
Big differences between floating statics and dialer watch:
[assumed dealing with ISDN]
Floating static: Need interesting traffic to trigger
All protocols
Only 1 router
Cannot trigger on threshold
Depend on routing protocol convergence time
Dialer watch: Route disapearing from routing table
Only IGRP/EIGRP/OSPF
Multiple routers
Can trigger on threshold
Very fast
-----Original Message-----
M> I have never used dialer watch but have seen a few threads on it's use
M> and I don't see much differance between it and a simple floating static
M> route, ( my method of choice).
M> I know I must be missing something...
M> Dave
M> syv wrote:
>>
>> On Tuesday, October 15, 2002, Azhar Mehmood wrote:
>>
>> Characteristics of dialer watch:
>>
>> * Watches specific routes in the routing table and initiates
>> backup link if the route is missing
>> * Encapsulation independent
>> * Evaluates status of primary link based on the existence of
>> routes to the peer. Hence it considers primary link status
>> based on the ability to pass traffic to the peer
>> Does not rely on interesting packets to trigger dialing
>> Dialing the backup link is done immediately when the primary
>> route is lost
>> * Dependent on the routing protocol convergence time
>> only IGRP/EIGRP/OSPF supported
>> * Supports multiple router backup scenario
>> * Bandwidth on demand is not possible since the route to the
>> peer will exist regardless of the load on the primary link
>> Triggered by:
>> 1. Interesting packets defined with DDR
>> 2. Connection loss on primary interface
>> 3. Traffic threshold being exceeded
>>
>> -----Original Message-----
>> AM> Hi,
>>
>> AM> I have a router R1 ehich has 3 exit points to reach a specific subnet:
>>
>> AM> 1. Ethernet
>> AM> 2. Serial
>> AM> 3. ISDN
>>
>> AM> As long the route over ethernet is available it's prefered over all other, after it has gone serial is prefered and as third option the ISDN Link.
>>
>> AM> Now my problem is how to keep ISDN Link down until both of the primary links are available. I tried to acomplish it with dialer watch but as soon as the ethernet is gone dialer watch triggers
>> the
>> AM> call hence it brings it also down again after idle-timeou
>> AM> t.
>>
>> AM> My question is how to configure the router that it waits until both of the link 're unavailable and triggering than an isdn call.
>>
>> AM> regards
>>
>> AM> AZHAR MEHMOOD
>> AM> GERMANY
>>
>> Thanks
>> --
>> syv@911networks.com
Thanks
-- syv@911networks.com
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:47 GMT-3