From: cebuano (cebu2ccie@cox.net)
Date: Mon Oct 14 2002 - 02:21:56 GMT-3
Hi all,
Following Solie's Lab 24, I'm trying to have the Hub configured with a
conditional default where it will no longer advertise the default route
when its Ethernet interface to the Internet router goes down. However,
as soon as the "route-map condition" is added to the "default-info orig
always", it just stops advertising the default regardless if its
Ethernet is up/down. Hub config is as follows.
dental-ho#s
!
interface Ethernet0
ip address 128.10.1.5 255.255.255.0
!
interface Serial0
no ip address
encapsulation frame-relay
!
interface Serial0.1 multipoint
ip address 172.16.1.5 255.255.255.0
ip ospf priority 255
frame-relay map ip 172.16.1.6 110 broadcast
frame-relay map ip 172.16.1.1 120 broadcast
!
interface Serial0.2 point-to-point
ip address 172.16.2.5 255.255.255.252
frame-relay interface-dlci 130
!
router ospf 2002
router-id 192.168.200.200
area 10 nssa default-information-originate
network 128.10.1.5 0.0.0.0 area 0
network 172.16.1.5 0.0.0.0 area 0
network 172.16.2.5 0.0.0.0 area 10
neighbor 172.16.1.1
neighbor 172.16.1.6
default-information originate always route-map condition
!
ip classless
ip default-network 128.10.0.0
!
ip prefix-list cond seq 5 permit 128.10.1.0/24
!
route-map condition permit 10
match ip address perfix-list cond
Any comments are greatly appreciated.
Elmer
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:46 GMT-3