From: Brian McGahan (brian@cyscoexpert.com)
Date: Sat Oct 12 2002 - 17:48:35 GMT-3
Azhar,
I'm not sure if there is a show command that will show you this,
however the config will. Split-horizon for IP EIGRP is on by default,
so 'ip split-horizon eigrp X' will not show up on the interface.
Therefore, since 'no ip split-horizon eigrp X' is a non default
configuration, it will appear in the running-configuration.
router(config)#int s0
router(config-if)#no ip split-horizon eigrp 1
router(config-if)#end
router#sh run int s0
Building configuration...
Current configuration : 106 bytes
!
interface Serial0
no ip address
no ip split-horizon eigrp 1
shutdown
end
router#
HTH
Brian McGahan, CCIE #8593
Director of Design and Implementation
brian@cyscoexpert.com
CyscoExpert Corporation
Internetwork Consulting & Training
http://www.cyscoexpert.com
Voice: 847.674.3392
Fax: 847.674.2625
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Azhar Mehmood
> Sent: Saturday, October 12, 2002 2:21 PM
> To: ccielab@groupstudy.com
> Subject: IP EIGRP SPLITHORIZON
>
> Hi guys,
>
> anybody who knows how to verify (command): wether splithorizon for
EIGRP
> is
> enabled or disabled.thanks
>
> regards
>
> Azhar Mehmood
> GERMANY
>
> [GroupStudy.com removed an attachment of type application/ms-tnef
which
> had a name of winmail.dat]
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:45 GMT-3