DLSW Border peer

From: Hedi Abdelkafi (Hedi.Abdelkafi@simac.lu)
Date: Thu Oct 10 2002 - 14:43:00 GMT-3

• Next message: Senthil Kumar: "vlan-map"
• Previous message: Hedi Abdelkafi: "RE: DLSW Lite on Hub-and-Spoke topology"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi,

Image the following DLSW topology :
I have 3 routers : RTA, RTB and RTC.
RTA is peering (DLSW) with RTB and RTC. RTB and RTC are connected to the
same Ring.
I would like that RTA will choose RTB as primary peer and if the link to RTB
fails, RTA will
switch to RTC (the backup peer).
I can easily do that with backup-peer command.

Now, I would like that all NEW PEER (RTA is configured as border peer) will
choose RTC
as the primary router and if this router fails, they will choose RTB.

All the configuration must be done on RTA (not on RTB or RTC with the cost
command).

Is it possible ?

Thanks for your help.

• Next message: Senthil Kumar: "vlan-map"
• Previous message: Hedi Abdelkafi: "RE: DLSW Lite on Hub-and-Spoke topology"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:44 GMT-3