From: esther (esther1616@hanmail.net)
Date: Wed Oct 09 2002 - 01:21:56 GMT-3
One more thing;
The following theory is correct what I understand??
when we configure the FR based on the point to point interface.
rip : doesn't need anything (only need the "no split-horizon on m-p int)
ospf : option 1 - put the neighbor command on both routers
option 2 - use "ip ospf network broadcast"
Please anyone confirm me?
Thanks in advnace,
Esther.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
esther
Sent: Wednesday, October 09, 2002 11:46 AM
To: ccielab@groupstudy.com
Subject: few questions on FR
Hi all again,
Please let me get answers for a few questions below.
1. neighbor command over FR (ospf)
The multi-point subinterfaces and p-t-p interfaces over FR should be
defined the "neighbor x.x.x.x" in the hub node (of course, we can also
use the ip ospf net type), Anyway does the neighbor command also need in
the spoke nodes as well? As a result of my test, it seems doesn't need in
the spoke sides. Any comment?
2. no frame inverse-arp
no arp frame
These two commands are always used as a pair command?
Thanks in advance,
Esther.
[TABLE NOT SHOWN]
[TABLE NOT SHOWN][TABLE NOT SHOWN][IMAGE]
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:43 GMT-3