From: ying c (bf5tgh1@yahoo.com)
Date: Mon Oct 07 2002 - 09:25:17 GMT-3
Hi,
span's equivalent in 3550 is monitor command. set port
security equivalent is 'switchport port-security'.
Use Practical Studies question you have and change the
port to 0/10, I would use
1. monitor session 1 source vlan 2 rx
monitor session 1 destination interface 0/10
Note: for port you can monitor rx and tx, for vlan
traffic you can monitor rx.
2. int fa0/x
switchport port-security (enable port security)
switchport port-security mac-address 3333.4444.5555
Chang
--- Jun Qian <johnjunqian@yahoo.com> wrote:
> Hi,guys,
>
> I got some questions about 3550.
>
> I know that cat 5500 support SPAN. For example.CCIE
> Practical Stufies Volume1 Page 1149.
> "configure the switchc so that all VLan 2 traffic
> can
> be monitored with a sniffer/anaylzer on port 2/10".
> On cat5500, we can issue "set span ...";
> But, I cannot some command to do on 3550!
> Another, what command replace "set port security 2/5
> 3333.4444.5555" on 3550?
>
> Do you have advice? Thanks!
>
> John
>
>
> __________________________________________________
> Do you Yahoo!?
> New DSL Internet Access from SBC & Yahoo!
> http://sbc.yahoo.com
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:41 GMT-3