From: Pieter Jordaan (pieterj@is.co.za)
Date: Tue Oct 01 2002 - 02:42:49 GMT-3
Hi
There are several commands to tweak the IPX rip and eigrp timers such as the
following
ipx rip-multiplier
ipx update time
ipx hold-down
ipx hold-time
hello interval
My question is this. Once you have changed the EIGRP update time or hold
time, where do you see what they are set to. The show ipx interface command
only show the rip timers, and the show ipx eigrp interface command doesn't
show much either (not even when I specify the detail option), thus none of
the show commands that I run seem the help much.
TIA
Pieter Jordaan
"This e-mail may contain confidential information and may be legally
privileged and is intended only for the person to whom it is addressed. If
you are not the intended recipient, you are notified that you may not use,
distribute or copy this document in any manner whatsoever. Kindly also
notify the sender immediately by telephone, and delete the e-mail. When
addressed to clients of the company from where this e-mail originates ("the
sending company ") any opinion or advice contained in this e-mail is subject
to the terms and conditions expressed in any applicable terms of business or
client engagement letter . The sending company does not accept liability for
any damage, loss or expense arising from this e-mail and/or from the
accessing of any files attached to this e-mail."
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:36 GMT-3