From: Adam Crisp (adam.crisp@totalise.co.uk)
Date: Sat Sep 28 2002 - 09:39:20 GMT-3
In order for you to talk rip, you need a network statment that matches the
Ethernet segment.
If you don't want to advertise this segment to another rip router then use a
distribute list
eg
interface loop 20
131.1.100.1 255.255.255.0
interface Ethernet0
ip address 151.1.100.1 255.255.255.0
router rip
network 131.1.0.0
network 151.1.0.0
distribute-list prefix rip_prefix out
!
ip prefix-list rip_prefix seq 5 permit 131.1.100.0/24
hope this helps....
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Robert Massiache
Sent: 28 September 2002 10:16
To: ccielab@groupstudy.com
Subject: Can't receive the routes...Help!
Hi all,
I got a questins for you all. Here the R2 is an unkown router running RIP.
No idea about what version. You need to receive the rotues from R2.
loop20-R1----Ethernet----R2
R1:
interface loop 20
131.1.100.1 255.255.255.0
interface Ethernet0
ip address 151.1.100.1 255.255.255.0
router rip
redistribute connected metric 2 route-map west
network 131.1.0.0
route-map west permit 10
match interface e0
route-map west permit 20
!
end.
How can I configure R1 to receive those R2 routes. I should only advertise
the loop 20 I should not advt. the Ethernet.
In all the above trials the RIP is not getting enabled on the Ethernet even
if I use access-list option insdie the route-map. Any help would be
appreciated.
thanks
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:44:05 GMT-3