From: Peng Zheng (zpnist@yahoo.com)
Date: Mon Sep 23 2002 - 02:37:29 GMT-3
Thanks.
--- elping <elpingu@acedsl.com> wrote:
> I think i did mention that 100 meg was needed to
> complete this task...This is
> what i have known and read...
>
> but I was able to configure on a 3600 router a 10
> meg only interface the
> following..
> so i think it is possible my friend....
>
> r7#conf t
> Enter configuration commands, one per line. End
> with CNTL/Z.
> r7(config)#int e2/1.1
> r7(config-subif)#en
> r7(config-subif)#encapsulation ?
> dot1Q IEEE 802.1Q Virtual LAN
> sde IEEE 802.10 Virtual LAN - Secure Data
> Exchange
>
> r7(config-subif)#encapsulation dot1Q ?
> <1-4095> IEEE 802.1Q VLAN ID required, range 1 -
> 0xFFF.
>
> r7(config-subif)#encapsulation dot1Q 1 ?
> <cr>
>
> r7(config-subif)#encapsulation dot1Q 1
>
>
>
>
>
> Ahmed Al-Ghawas wrote:
>
> > Regardless of the router model, you can only
> configure isl on an 100Mbps
> > port. Configure it on an 10Mpbs port is not
> possible.
> >
> > HTH
> >
> > Ahmed
> >
> > ----- Original Message -----
> > From: "Peng Zheng" <zpnist@yahoo.com>
> > To: <ccielab@groupstudy.com>
> > Sent: Saturday, September 21, 2002 9:07 PM
> > Subject: Is it possible to config bridge under
> sub-interface for 2500 series
> > router?
> >
> > > Hi,
> > >
> > > I tried, but it said sde or isl encapsulation is
> > > required. But it's not a choices under the
> interface.
> > >
> > > Thank you for help.
> > >
> > > Best Wishes,
> > > Peng Zheng
> > >
> > >
> __________________________________________________
> > > Do you Yahoo!?
> > > New DSL Internet Access from SBC & Yahoo!
> > > http://sbc.yahoo.com
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:44:00 GMT-3