From: Nigel Taylor (nigel_taylor@hotmail.com)
Date: Sat Sep 21 2002 - 02:27:20 GMT-3
Prakash,
I performed a quick search on CCO using "h323-gateway voip bind
srcaddr"
and found this link.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4224/sw_confg/overvie
w.htm#xtocid38
watch the line wrap...:-)
I think this should get you heading in the right direction.
Nigel
----- Original Message -----
From: "Prakash H Somani" <pdsccie@rediffmail.com>
To: <ccielab@groupstudy.com>
Sent: Saturday, September 21, 2002 12:44 AM
Subject: VoIP Dial-peer issue
> Hi Group,
>
> One of my friend gave me following scenario which I m not able to
> crack:
>
> L0---R1---IP Network---------R8---L100
>
>
> R1 Loopback address: 150.10.1.1
> R1 Serial address: 150.10.100.1/24
> R1 phone no is: 1111
>
> R8 Loopback address:150.10.8.8 (There are multiple loopbacks on
> this R8 routers and all the routes are available on R1)
> R8 Serial address:150.10.80.1/24
> R8 phone no is 8888
>
> Now R8 config is not in my control. He has configured it and put
> enable password.
>
> He wants me to configure a Voip Dial-peer on my R1 router with
> correct session-target address. (Where he has bind using
> "h323-gateway voip bind srcaddr"
>
> If I bind my VoiP dial-peer with serial interface as below:
>
> #dial-peer voice 10 pots
> destination-pattern 1111
> port 1/0/0
>
> #dial-peer voice 80 voip
> destination-pattern 8888
> session-target ipv4:150.10.80.1
>
> I am getting one-way voice and distorted voice.....what he expects
> is I should find out his Voip binding address....
>
> IS this possible ??? I tried with all debug commands but not
> getting any result....(He has gone on leave so not
> contactable....)
>
> Does anybody know solution?
>
> regards....Prakash
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:59 GMT-3