From: beda jain (bpjain@cisco.com)
Date: Tue Sep 17 2002 - 17:45:25 GMT-3
What is use of default here ????
At 04:03 PM 9/17/2002 -0400, Raj Thava[IPC_Head Office] wrote:
>if you wnt to onfigure ipx tunnel over ip thent first make sure you have
>connectivity between the routers using ip then
>
>R1
>
>interface tunnel 0
>tunnel source - - - -
>tinnel destination - - - -
>ipx ipxwan 0 unnumbered R1
>
>
>R3
>
>tunnel source - - - -
>tinnel destination - - - -
>ipx ipxwan 0 unnumbered R3
>
>This will connect R1 and R3 through the ipx
>
>Raj
>
>-----Original Message-----
>From: Peng Zheng [mailto:zpnist@yahoo.com]
>Sent: September 17, 2002 3:47 PM
>To: ccielab@groupstudy.com
>Subject: IPX config
>
>
>Hi,
>
>Below is the senario:
>
>R1-----R2-----R3---(others)
>
>The requirement is:
>
>Not run IPX on R2.
>
>R1 use R3 as default route.
>
>R1 need to propogate a IPX network to R3 and other
>network.
>
>R1, R2, R3 have IP connection.
>
>How should it be implemented?
>
>I think it should be done by tunnel, but I can't
>figure out how to config?
>
>Thanks for help.
>
>
>Best Wishes,
>Peng Zheng
>
>__________________________________________________
>Do you Yahoo!?
>Yahoo! News - Today's headlines
>http://news.yahoo.com
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:54 GMT-3