From: Phil (ciscostudent1@yahoo.com.br)
Date: Tue Sep 03 2002 - 13:58:53 GMT-3
I used only Hyperterm and TeraTerm. On Hyperterm it's pretty straight forward, you can change the delay in either serial or telnet connections. Teraterm allows you to change only in the serial connection.
Hyperterm: File, Properties, Settings, ASCII Setup... Then set as follows:
Line delay: 500-750 milliseconds
Character delay: 1 milliseconds
I don't have TeraTerm handy to show you now.
HTH,
Phil
Donny MATEO <donny.mateo@sg.ca-indosuez.com> escreveu: hmm..
term rxspeed ?
term telnet speed ?
care to elaborate how to change delay to 1 msec and line delay between 500-750 msec on the various
software used at CCIE lab ?
thx
Donny
Phil
, "'Groupstudy'"
hoo.com.br>
Sent by: cc:
nobody@groupstudy Subject: RE: Ping Script? re-phrase
.com
03-09-2002 05:47
Please respond to
Phil
William,
To make it work you have to change the character delay to 1 msec and the line delay between 500 and
750 msec in the terminal emulator software.
Phil
William Wong Kun Sing escreveu: Guys,
Sorry, what i mean is after i have finished my lab and want to test the
routing info for all the routers. Like for example use the notepad to have
multiple ping command as the below:
ping 1.1.1.1
ping 1.1.2.1
ping 1.1.3.1
and copy & paste on the routers. I have tried that but it will only ping
the first address and then stop. I need a ping script which can ping all
the interfaces to save some expensive time.
Thanks.
Best regards,
William
-----Original Message-----
From: Dimitris Vassilopoulos [mailto:Dimitris.Vassilopoulos@eurodyn.com]
Sent: Tuesday, September 03, 2002 2:05 PM
To: William Wong Kun Sing
Cc: 'Groupstudy'
Subject: Re: Ping Script?
Try the extended ping, with the repeat count set to more than the
default:
Router#ping
Protocol [ip]:
Target IP address: x.x.x.x
Repeat count [5]: 100
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 100, 100-byte ICMP Echos to x.x.x.x, timeout is 2 seconds:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Success rate is 100 percent (100/100), round-trip min/avg/max = 1/2/4 ms
Router#
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:42 GMT-3