From: Omer Ansari (omer@ansari.com)
Date: Sun Sep 01 2002 - 21:59:38 GMT-3
All,
doing a lab where theres a requirement to set a privelege level to only
allow show commands.
researched the archive, as well as tried a few iterations, but even for
level1 i end up getting all sort of options other than show:
R1(config)#username cisco privilege 1 nopassword
R1#sr | inc (user|priv)
username cisco nopassword
privilege exec level 1 show
then i try to telnet in remotely.
R9#telnet 1.1.1.1
...
Username: cisco
R1>?
Exec commands:
<1-99> Session number to resume
access-enable Create a temporary Access-List entry
access-profile Apply user-profile to interface
clear Reset functions
...
I still have a choice of all the other commands as you can see..
how can i configure R1, so that when I log in I get only this:
R1>?
Exec commands:
show Show running system information
exit ..
[and other mandatory level0 commands]
R1>
regards,
Omer
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:41 GMT-3