From: Guoqi Cui (guoqicui@yahoo.com)
Date: Sun Sep 01 2002 - 14:55:01 GMT-3
You should use " fram map dlsw dlci #" if you use
passthrough.
--- Frank <frank@buff-net.com> wrote:
> Jin,
>
> LLC2 provides local acknowledgment, but when you
> use the
> pass-thru keyword you're saying don't use local
> acknowledgment. When
> you use pass-thru you must map into "dlsw" vice
> LLC2. This is DIRECT
> encapsulation.
>
> Leave off the pass-thru and you have LLC2 or DLSw
> Lite
> encapsulation. Then you must map to LLC2 as you
> have below.
>
> Unless you're on a sub-interface then of course use
> the
> 'frame-relay interface-dlci N' command.
>
> HTH...aloha, Frank
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com] On Behalf Of
> jin
> Sent: Saturday, August 31, 2002 11:12 AM
> To: ccielab@groupstudy.com
> Subject: dlsw...
>
> I'm testing fr map.
> But dlsw peer is 'disconnect' state still.
> I configured it as the cisco guide.
> First, dlsw remote 0 frame inter s 0 16 pass-th
> and then, in the inface config mode make 'fr map
> llc2 dlci'
> But now it is disconnct state..
>
> Do I have a problem that I don't know still?
>
> Thanks.
>
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:41 GMT-3