From: Brian Dennis (brian@xxxxxx)
Date: Fri Aug 23 2002 - 14:34:11 GMT-3
http://www.faqs.org/rfcs/rfc2328.html
12.4.1.4. Describing Point-to-MultiPoint interfaces
For operational Point-to-MultiPoint interfaces, one or
more link descriptions are added to the router-LSA as
follows:
o A single Type 3 link (stub network) is added with
Link ID set to the router's own IP interface
address, Link Data set to the mask 0xffffffff
(indicating a host route), and cost set to 0.
o For each fully adjacent neighbor associated with the
interface, add an additional Type 1 link (point-to-
point) with Link ID set to the Router ID of the
neighboring router, Link Data set to the IP
interface address and cost equal to the interface's
configured output cost.
Brian Dennis, CCIE #2210 (R&S/ISP Dial)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ccie candidate
Sent: Friday, August 23, 2002 9:49 AM
To: ccielab@groupstudy.com
Subject: ospf over frame /32 route
folks
when i was doing ospf over frame ..i had the hub as multipoint .
i noticed that /32 routes of the spokes are installed in the routing
table ..is this normal ...is there anyway to get rid of it .
im already using ip ospf network point-to-multipoint on the interfaces .
thanks
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:35 GMT-3