From: thunai@xxxxxxxxxxxx
Date: Fri Aug 23 2002 - 05:26:12 GMT-3
It just adds the metric . I want to subract the metric and install in the
local router table
> -----Original Message-----
> From: Asim Khan [SMTP:asimmegawatt@yahoo.com]
> Sent: Friday, August 23, 2002 1:39 PM
> To: thunai@netsol.co.in; ccielab@groupstudy.com
> Subject: Re: Intersting Question on RIP metric
>
> Thunai,
>
> You can do the following configuratin on R2.
>
> R1(config)#access-list 1 permit <address> <mask>
>
> where <address> is the address whose metric is to be
> manipulated.
>
> R1(config)#router rip
> R1(config-router)#network x.x.x.x
> R1(config-router)#offset-list 1 in 3 <int-name>
>
> where 3 is the metric.
>
> Regards.
>
> Asim Khan
>
>
> --- thunai@netsol.co.in wrote:
> > Hai Group ,
> > Two routers r1-r2 running RIP , r1 is giving some
> > routes to r2
> > with a metric of 5 but i want r2 to install that
> > routes with a metric of 3
> > . I was wondering how to use offset-list command to
> > subract metric . If u
> > look at the description of offset-list command its
> > says u can add / sub . If
> > u use offset in / out it simply add the metric .Can
> > some throw some light
> > on this..
> >
> >
> > Thanks in advance
> > thunai
> >
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:35 GMT-3