From: Geoff Zinderdine (geoffz@xxxxxxx)
Date: Wed Aug 21 2002 - 19:09:35 GMT-3
As you can see below, ip addresses are still supported in 12.1 T-train.
Geoff Zinderdine
Aegis Network Consulting
Rack05R2#sho ver
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-JOS56I-L), Version 12.1(5)T9, RELEASE
SOFTWARE (f
c1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Mon 25-Jun-01 01:43 by cmong
Image text-base: 0x0307EE20, data-base: 0x00001000
ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
BOOTFLASH: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE
SOFT
WARE (fc1)
Rack05R2 uptime is 1 day, 14 hours, 29 minutes
System returned to ROM by reload
System image file is "flash:c2500-jos56i-l.121-5.T9.bin"
cisco 2500 (68030) processor (revision N) with 14336K/2048K bytes of memory.
Processor board ID 08796172, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2102
Rack05R2#sb
Interface IP-Address OK? Method Status
Prot
ocol
Ethernet0 unassigned YES unset administratively down
down
Serial0 unassigned YES manual up
up
Serial1 unassigned YES manual up
up
Virtual-TokenRing10 10.1.1.1 YES manual up
up
Rack05R2#sho run int vir
Rack05R2#sho run int virtual-TokenRing 10
Building configuration...
Current configuration : 90 bytes
!
interface Virtual-TokenRing10
ip address 10.1.1.1 255.255.255.0
ring-speed 16
end
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ashok.Gupta
Sent: Wednesday, August 21, 2002 2:49 AM
To: 'Johnny Tsao'; 'R&S'
Subject: RE: virtual-tokenring interface...
Hi,
I had similar problem, you will find that you are not able to assign IP
addresses to virtual token ring in OS 12.1, if you try os 12.0(16) or lower
should be ok
Ashok
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Johnny Tsao
Sent: 21 August 2002 04:59
To: R&S
Subject: virtual-tokenring interface...
Router4(config)#int virtual-TokenRing 0
Router4(config-if)#ip add
Router4(config-if)#ip address 192.168.1.1 255.255.255.0
% IP addresses may not be configured on a Virtual-TokenRing interface.
Router4(config-if)#
do you have to specify a global command or something else? I'm running
IOS 12.1. However, ipx network command works. go figure.
Johnny Tsao, CCIE 8759
Network Catalyst, Inc.
Network Operations Center
www.netcat.com
netcat_noc@netcat.com
877-638-2287 Opt. 1
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:32 GMT-3