From: Colin Barber (Colin.Barber@xxxxxxxxxxxxxx)
Date: Sun Aug 18 2002 - 11:38:23 GMT-3
Port priority is used to prioritise ports when the backplane of the Cat is a
full capacity. I believe that the capacity of the backplane on the 3550 is
greater than the combined capacity of the port and therefore you would not
have this situation.
Colin
-----Original Message-----
From: dwclemons [mailto:dwclemons@msn.com]
Sent: 18 August 2001 14:42
To: ccielab@groupstudy.com
Subject: 3550
Does anyone know if there is a similar command on the 3550 to allow certain
ports to have a priority over other ports.
set port level 1/2 high
Thanks
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:28 GMT-3