From: Edward Monk (emonk@xxxxxxx)
Date: Tue Aug 06 2002 - 13:03:34 GMT-3
9.2
use IRDP on the router
2.2
Configure Quality of service for vlans. You have to map a CoS value to
the mac-address and vlan pair. (set qos mac-cos dest_MAC_addr VLAN
cos_value)
I don't think its currently tested on because was not implemented until
Version 5.2 on the Cat5000. I think we are only tested on 4.5 features
of the Cat5000. But I could be wrong. I would go over it even if my test
was before Nov. 4th. Better safe than sorry.
11.1
line con 0 or vty x
privilege level 15
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Zhang, Ou (David)
Sent: Tuesday, August 06, 2002 8:35 AM
To: 'ccielab@groupstudy.com'
Subject: CCIE Practical Studies
Hello,
I'm totally stuck with the following questions from the CCIE Practical
Studies vol. 1. I'd appreciate any answers, hints or suggestions.
Thanks.
p. 1167
9.2 Configure R3 so that workstations in Vlan 30 can dynamically
locate
their default gateway. They are not using DHCP. (R3 hosts Vlan 30.)
p. 1175
2.2 Configure the Catalyst so that if the backplane of the switch
gets
overloaded, the ports in VLAN 30 get serviced before those in VLAN 50.
(The
switch hosts these two vlans in question.)
p. 1177
11.1 Configure R1 so that when the user unnamed logs into the router,
that user immediately is put in enable mode.
-David
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:17 GMT-3