From: kasturi cisco (kasturi_cisco@xxxxxxxxxxx)
Date: Mon Jul 29 2002 - 15:06:59 GMT-3
Ademola,
U need the dialer map for each prefix which is being watched when u are
using Physical interfaces not with dialer interfaces. Each prefix must also
be in the dialer-watch list (same network and mask) as in route table.
http://www.cisco.com/warp/public/129/bri-backup-map-watch.html.
HTH,
kasturi
>From: Ting Chung <twchungca@yahoo.com>
>Reply-To: Ting Chung <twchungca@yahoo.com>
>To: Ademola Osindero <osindero@lagos.sns.slb.com>,
>"'ccielab@groupstudy.com'" <ccielab@groupstudy.com>
>Subject: ISDN Dialer Watch
>Date: Mon, 29 Jul 2002 06:53:44 -0700 (PDT)
>
>Ademola, the common overlook of setting up dialer
>watch is missing the "dialer map" statement pointing
>to the "watch-list" prefixes that you are "watching".
>It is only needed if you are configuring the dialer
>watch using dialer map. If you are using dialer
>profile, you do not need that statement. It took me a
>while to figure all these out.
>
>
>--- Ademola Osindero <osindero@lagos.sns.slb.com>
>wrote:
> > (To be frank, I setup
> > dialer watch for OSPF and it didn't work. Why? I
> > haven't checked that yet).
> >
> > Ademola
> >
>
>
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:48 GMT-3