From: Jonathan V Hays (jhays@xxxxxxxx)
Date: Fri Jul 26 2002 - 15:03:42 GMT-3
You say "I don't know is *this* acceptable? What specifically are you
concerned about? If the instructions in your problem say to configure
loopbacks and you configure loopbacks, what's wrong with that? Are there
additional instructions or requirements?
As to whether it is acceptable in the CCIE Lab, the only person who can
answer that is the lab proctor. And it also depends on the instructions
in the Lab booklet.
-Jonathan
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Armand D
Sent: Friday, July 26, 2002 7:53 AM
To: ccielab@groupstudy.com
Subject: loopback interface in OSPF
Hi,
As I understand a loopback interface in OSPF will be
advertised as stub network with bit mask /32.
My question says " No other interfaces should be
configured in OSPF area except loopbacks" I don't know
is this acceptable by CCIE lab proctor or must I
change the OSPF network type or summary the address
with command area xxx range y.y.y.y mask on ABR router
??
Any info would be appreciated.
Armand
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:45 GMT-3