From: Ouellette, Tim (tim.ouellette@xxxxxxx)
Date: Tue Jul 23 2002 - 05:37:40 GMT-3
If you trying to "route" over it. Try adding "async default routing" to
your config
Specify asynchronous dynamic routing on the interface. The async dynamic
routing command allows routing protocols to be run over the asynchronous
interface to resolve IP routes dynamically. If the command is omitted,
static routes can still be used.
Snoopy(config-if)# async dynamic routing
Check out this great link too..
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12supdoc/dsq
cg3/qcddr.htm
Tim
-----Original Message-----
From: Waqar Ahmed [mailto:waqarahmed_11@yahoo.com]
Sent: Tuesday, July 23, 2002 12:21 AM
To: cisco@groupstudy.com
Subject: dialup configuration [7:49423]
Hi,
I have configure AUX port for routing and need to
configure asyn port s0/0. Need the configuration for
both to work simultaneously. AUX port configuration is
as.
interface Async65
ip address 10.190.6.1 255.255.255.252
no ip directed-broadcast
encapsulation ppp
keepalive 30
async mode dedicated
peer default ip address 10.190.6.2
no cdp enable
ppp authentication pap
line aux 0
no exec
modem InOut
modem autoconfigure discovery
transport input all
stopbits 1
flowcontrol hardware
Regards
Waqar Ahmed
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:40 GMT-3