From: Nick Shah (nshah@xxxxxxxxxxxxxx)
Date: Mon Jul 22 2002 - 23:03:50 GMT-3
Edward
I am assuming you are using extended access lists to match on source &
destination.
Can you post the access list ?
Nick
----- Original Message -----
From: "Edward Monk" <edmonk@attbi.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, July 23, 2002 4:16 AM
Subject: Local Policy Routing and Setting Precedence
> I am having trouble with setting the precedence on a local policy
> route-map. When I try to set the precedence to any value it is rejected.
> If I take out the set precedence value and instead set the next-hop in
> the route-map it matches the access-list (just like with set ip
> precedence )and is routed per route-map (unlike precedence). Is there
> something obvious I am missing here?
>
>
>
> Below are the outputs with the route-map and the appropriate debugs. My
> access-list permits ip any any. I have tried to specify source and
> destination in access-list but the results are the same.
>
>
>
> R13#sh route-map
>
> route-map r13_local, permit, sequence 10
>
> Match clauses:
>
> ip address (access-lists): 150
>
> Set clauses:
>
> ip next-hop 172.16.134.4
>
> Policy routing matches: 120 packets, 10620 bytes
>
>
>
> R13#ping 172.16.100.6
>
> Type escape sequence to abort.
>
> Sending 5, 100-byte ICMP Echos to 172.16.100.6, timeout is 2 seconds:
>
> !!!!!
>
> Success rate is 100 percent (5/5), round-trip min/avg/max = 116/119/124
> ms
>
>
>
> R13#
>
> 23:59:13: IP: s=172.16.13.1 (local), d=172.16.4.1, len 40, policy match
>
> 23:59:13: IP: route map r13_local, item 10, permit
>
> 23:59:13: IP: s=172.16.13.1 (local), d=172.16.4.1 (FastEthernet0/0), len
> 40, policy routed
>
> 23:59:13: IP: local to FastEthernet0/0 172.16.134.4
>
>
>
> R13#sh route-map
>
> route-map r13_local, permit, sequence 10
>
> Match clauses:
>
> ip address (access-lists): 150
>
> Set clauses:
>
> ip precedence internet
>
> Policy routing matches: 133 packets, 11625 bytes
>
> R13#ping 172.16.100.6
>
>
>
> Type escape sequence to abort.
>
> Sending 5, 100-byte ICMP Echos to 172.16.100.6, timeout is 2 seconds:
>
> !!!!!
>
> Success rate is 100 percent (5/5), round-trip min/avg/max = 117/120/125
> ms
>
> R13#
>
> 1d00h: IP: s=172.16.134.13 (local), d=172.16.100.6, len 100, policy
> match
>
> 1d00h: IP: route map r13_local, item 10, permit
>
> 1d00h: IP: s=172.16.134.13 (local), d=172.16.100.6, len 100, policy
> rejected -- normal forwarding
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:40 GMT-3