From: Anthony Pace (anthonypace@xxxxxxxxxxx)
Date: Fri Jul 19 2002 - 18:46:16 GMT-3
I noticed the same thing as Andy. I think that "bridge 1 bridge ipx" is
a default and does not display but it allows the IPX traffic to be
bridged on all the interfaces in Bridge group 1. In order to get the
BVI connectivity into the BRIDGE-GROUP, you need "bridge 1 route ipx".
These two commands are "per protocole being bridged or routed. Routed,
means that the BVI will provide a layer 3 address for the whole
broadcast domain which is the briged interfaces.
The bridge, no bridge, route, no route commands seem to be auto
generated, depending on the order you do things. (Bridge-group, BVI,
putting interfaces in the bridge group) and depending if you allready
had layer 3 interfaces for a particular protocole on a particular
interface.
Also; isn't it necessary to disable the IPX reserved netwok of FFFFFFE
if you want to actually use it fot your LAN?
Anthony Pace
On Fri, 19 Jul 2002 15:38:19 -0500, "Diment, Andrew"
<adiment@qwest.com> said:
> I assume you are saying it's not passing IP because there is no "bridge
> 1
> route ipx". This should work. Looking at the "show ver" I notice the
> router has been up for 2 days. Did you try to reboot the router? I
> have
> found if you are making changed and it looks like it should work but
> doesn't
> a reboot will usually fix it.
>
> Andy
>
> -----Original Message-----
> From: Rich Kleimon [mailto:richard_kleimon@qwest.net]
> Sent: Friday, July 19, 2002 1:37 PM
> To: ccielab@groupstudy.com
> Subject: BVI Problem
>
>
> Having trouble with a BVI. I know this should work because I have done
> it on
> different equip.. It doesn't pass any traffic.
> Any thoughts?
>
> bridge irb
>
> interface FastEthernet1/0
> no ip address
> no ip directed-broadcast
> full-duplex
> !
> interface FastEthernet1/0.10
> encapsulation isl 10
> ip address 135.6.32.6 255.255.255.0
> no ip redirects
> no ip directed-broadcast
> ipx encapsulation NOVELL-ETHER
> ipx network 56
> !
> interface FastEthernet1/0.20
> encapsulation isl 20
> no ip redirects
> no ip directed-broadcast
> bridge-group 1
> !
> interface FastEthernet1/0.40
> encapsulation isl 40
> no ip redirects
> no ip directed-broadcast
> bridge-group 1
> !
> interface BVI1
> ip address 135.6.33.6 255.255.255.0
> no ip directed-broadcast
> ipx network FFFFFFFE
>
> bridge 1 protocol ieee
> bridge 1 route ip
>
>
> R6#sh ver
> Cisco Internetwork Operating System Software
> IOS (tm) C2600 Software (C2600-JS-M), Version 12.0(21a), RELEASE
> SOFTWARE
> (fc1)
> Copyright (c) 1986-2002 by cisco Systems, Inc.
> Compiled Sat 02-Feb-02 00:58 by nmasa
> Image text-base: 0x80008088, data-base: 0x80B1D42C
>
> ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
>
> R6 uptime is 2 days, 4 hours, 27 minutes
> System restarted by power-on
> System image file is "flash:c2600-js-mz.120-21a.bin"
>
> cisco 2610 (MPC860) processor (revision 0x202) with 29696K/3072K bytes
> of
> memory.
> Processor board ID JAD04011VDX (943008882)
> M860 processor: part number 0, mask 49
> Bridging software.
> X.25 software, Version 3.0.0.
> SuperLAT software (copyright 1990 by Meridian Technology Corp).
> TN3270 Emulation software.
> 1 Ethernet/IEEE 802.3 interface(s)
> 1 FastEthernet/IEEE 802.3 interface(s)
> 1 Serial network interface(s)
> 2 Serial(sync/async) network interface(s)
> 32K bytes of non-volatile configuration memory.
> 8192K bytes of processor board System flash (Read/Write)
>
> Configuration register is 0x2102
>
>
> Console> (enable) sh port 1/2
> Port Name Status Vlan Level Duplex Speed Type
> ----- ------------------ ---------- ---------- ------ ------ -----
> ------------
> 1/2 connected trunk normal full 100
> 100BaseTX
>
> Port Security Secure-Src-Addr Last-Src-Addr Shutdown Trap
> IfIndex
> ----- -------- ----------------- ----------------- -------- --------
> -------
> 1/2 disabled No disabled 4
>
> Port Broadcast-Limit Broadcast-Drop
> -------- --------------- --------------
> 1/2 - -
>
> Port Status Channel Channel Neighbor
> Neighbor
> mode status device port
> ----- ---------- --------- ----------- -------------------------
> ----------
> 1/2 connected auto not channel
>
> Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize
> ----- ---------- ---------- ---------- ---------- ---------
> 1/2 8 13 0 21 0
>
> Port Single-Col Multi-Coll Late-Coll Excess-Col Carri-Sen Runts
> Giants
> ----- ---------- ---------- ---------- ---------- --------- ---------
> ---------
> 1/2 1 0 0 0 0 2
> -
>
> Last-Time-Cleared
> --------------------------
> Sat Jul 6 2002, 18:27:39
>
> Console> (enable) sh ver
> WS-C5000 Software, Version McpSW: 4.5(13a) NmpSW: 4.5(13a)
> Copyright (c) 1995-2002 by Cisco Systems
> NMP S/W compiled on Feb 4 2002, 16:46:59
> MCP S/W compiled on Feb 04 2002, 16:48:19
>
> System Bootstrap Version: 2.4(1)
>
> Hardware Version: 2.1 Model: WS-C5000 Serial #: 007408581
>
> Mod Port Model Serial # Versions
> --- ---- ---------- --------- ----------------------------------------
> 1 2 WS-X5509 007408581 Hw : 2.1
> Fw : 2.4(1)
> Fw1: 2.4(1)
> Sw : 4.5(13a)
> 2 12 WS-X5213A 005150972 Hw : 1.1
> Fw : 1.4
> Sw : 4.5(13a)
>
> DRAM FLASH NVRAM
> Module Total Used Free Total Used Free Total Used Free
> ------ ------- ------- ------- ------- ------- ------- ----- -----
> -----
> 1 16384K 10163K 6221K 8192K 3840K 4352K 256K 113K
> 143K
>
> Uptime is 12 days, 17 hours, 35 minutes
> Console> (enable)
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:37 GMT-3