Re: bootflash failed?

From: kym blair (kymblair@xxxxxxxxxxx)
Date: Wed Jul 10 2002 - 06:42:53 GMT-3


   
Yeung,

Bootflash for the 4500M is cheap. Bootflash uses the same stick as flash.
Also, the 4500M uses the same Flash memory as in the 2500, so you can pick
it up cheap on eBay. When you're looking at the 4500M from the rear
(looking at the interface module side), you'll see three flash sticks in the
rear right. The furthest right is the Bootflash; the two to the left are
regular flash. Just use a regular 8MB flash stick and load it with the BOOT
image.

HTH, Kym

>From: Katson Yeung <kyeung@hkcix.com>
>Reply-To: Katson Yeung <kyeung@hkcix.com>
>To: Phil <ciscostudent1@yahoo.com.br>
>CC: ccielab@groupstudy.com
>Subject: Re: bootflash failed?
>Date: Tue, 9 Jul 2002 22:23:08 +0800 (HKT)
>
>Yep, I think so.... I may do it and rub the golden-finger with some fine
>sand-eraser.... May do it later since I will be on business trip tomorrow.
>
>Will let all of you know the result. Thanks
>
>
>
>On Tue, 9 Jul 2002, Phil wrote:
>
> > Katson,
> > Did you try to reseat the flash card? Could be a image problem. Also,
>try to boot from a tftp server to make sure everything else works on the
>router.
> >
> > Katson PN Yeung <kyeung@hkcix.com> escreveu: Dear all,
> >
> > Below is how my bootflash look like in my 4500M. Do you think the
>bootflash
> > is dead?
> >
> > Any way to recover this baby?
> >
> >
> > rommon 2 > dev
> > Devices in device table:
> > id name
> > flash: flash
> > bootflash: boot flash
> > eprom: eprom
> >
> >
> > rommon 3 > dir bootflash:
> > bus error while trying to access flash - addr = 0xb8000000
> > cannot read flash info
> > getdevnum warning: device "boot flash" has size of zero
> > bus error while trying to access flash - addr = 0xb8000000
> > cannot read flash info
> > getdevnum warning: device "boot flash" has size of zero
> > bus error while trying to access flash - addr = 0xb8000000
> > cannot read flash info
> > getdevnum warning: device "boot flash" has size of zero
> > bus error while trying to access flash - addr = 0xb8000000
> > cannot read flash info
> > getdevnum warning: device "boot flash" has size of zero
> > open: read error...requested 0x4 bytes, got 0xffffffff
> > trouble reading device magic number
> > dir: cannot open device "bootflash:"
> >
> >
> >
> > Cheers,
> > K a t s o n
> > CCIE # 9620



This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:24 GMT-3