From: steven.j.nelson@xxxxxx
Date: Fri Jul 05 2002 - 06:34:58 GMT-3
Kym
I have this working no sweat, I have neighbor statements on the hub priority
100 (multipoint) and prior 0 on each spoke, the spokes are (DROTHER) and the
hub is (DR), MD5 in operation over the whole of area 0.
Do you want the configs ?
Thanks
Steve
-----Original Message-----
From: kym blair [mailto:kymblair@hotmail.com]
Sent: 04 July 2002 23:04
To: ccielab@groupstudy.com
Cc: tlarus@cox.net; nshah@connect.com.au
Subject: OSPF md5 authentication
This has been discussed several times, but I haven't see a working solution
and hope someone has it:
--MD5 authentication in area 0 over Frame Relay
--hub router (multipoint subinterface; okay to change the ospf network type)
-- two spoke routers (physical serial interface; cannot change the interface
type from non-broadcast [this means that the three routers must elect DR;
you may set the priority to 0 on the spoke routers]).
Adjacencies without authentication, but when a message-digest-key is added
to the three, the hub router forms an adjacency with only one of the spokes.
Generates a mismatch key error with the second spoke router.
If you know the trick to get the hub to form adjacencies with both spokes,
I'd sure appreciate hearing it.
Thanks,
Kym
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:19 GMT-3