From: Gev, Chaim (Chaim.Gev@xxxxxx)
Date: Tue Jul 02 2002 - 03:31:28 GMT-3
As stated in the IOS documentation: "For OSPF, this command summarizes only rou
tes from other routing protocols that are being redistributed into OSPF". So, s
ummary-address will not summarize our loopbacks if we run OSPF on these interfa
ces.
The requirement is to use a /32 mask for the loopbacks. So setting network type
on these interfaces will not make any change.
-----Original Message-----
From: Andy Hoang [mailto:ahoang@sbcglobal.net]
Sent: Tuesday, July 02, 2002 7:49 AM
To: Gev, Chaim; ccielab@groupstudy.com
Subject: RE: Summarizing from OSPF
Use area range command for inter areas and summary-address for inter AS.
For example "area 0 range 192.168.1.0 255.255.255.0" or "summary-address
192.168.1.0 255.255.255.0"
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of Gev,
Chaim
Sent: Sunday, June 30, 2002 11:59 PM
To: ccielab@groupstudy.com
Subject: Summarizing from OSPF
Hi,
[r1]---igrp---[r2]---area0--[r3]---area0----[r4]----area1---
each router has a loopback interface addressed 135.1.n.n/32
Routing protocol is running on the loopback interfaces (using network
command).
How would you summarize these loopback addresses from OSPF to /24 if you
aren't allowed
to use static routes.
I believe that this subject was discussed on this group but since the search
isn't working
can someone point to the right thread?
Chaim Gev
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:17 GMT-3