From: Denise Donohue (denise@xxxxxxxxxx)
Date: Sun Jun 30 2002 - 15:34:21 GMT-3
Thomas answered your second question, so I'll try the first. There is a
tunnel between R2 and R4 that runs EIGRP. Check to make sure that the
end-points of this tunnel are interfaces that are advertised only in OSPF,
and not EIGRP. As a general rule, you want to advertise the end-points of
your tunnel with a different routing protocol than you are sending through
the tunnel.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
kym blair
Sent: Sunday, June 30, 2002 12:07 AM
To: ccielab@groupstudy.com
Subject: CyscoExpert Lab Questions
Does anyone have a working solution for the CyscoExpert sample lab?
(1) I'm having a major route flapping problem on R1. I've solved it using a
tunnel between R2 and R1 and added it to EIGRP, but am not happy with that
solution. There must be a better way.
(2) Also, can't figure out how to meet DLSW+ requirement H.2(3): R3 should
not get any NetBIOS explorer traffic.
Thanks. Kym
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:44 GMT-3