From: Bruce Rogers (brogers@xxxxxxxxxxxxx)
Date: Wed Jun 26 2002 - 16:03:14 GMT-3
Ahmed,
Yes, this works the same in EIGRP as it did in IGRP. I believe this will answer
your question.
http://www.cisco.com/warp/public/103/19.html
Bruce
-----Original Message-----
From: Ahmed Al-Ghawas [mailto:ghawas@batelco.com.bh]
Sent: Wed 6/26/2002 2:28 PM
To: ccielab@groupstudy.com
Cc:
Subject: Unequal Load Sharing using EIGRP
Can anyone tell me if EIGRP works in the same fashion IGRP in terms of
Load
Sharing on different link speeds?
I know that on IGRP you can do that by specifying the bandwidth command
under
each serial port you wish to load balance then by configuring the varia
nce
using the below formula:
variance = 1+ (high_cost_path/lowest_cost_path)
Is this possible on EIGRP? Or is there a different way to do it?
Appreciate anyone's help
Thanks,
Ahmed
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:42 GMT-3