From: Sahibzada Baleeghuddin Afridi (baleegh@xxxxxxxxxxxxx)
Date: Wed Jun 19 2002 - 03:36:41 GMT-3
I think you can also follow this command
R1(config)#dlsw explorerQ-depth 150
Old style DLSw Explorer Queue Depth command encountered.
Current or Default values will be maintained.
R1(config)#dlsw explorerQ-depth sna 150
this gives you no error message ......HTH
Regards
Baleegh
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
George Spahl
Sent: Monday, June 17, 2002 5:41 PM
To: 'sovan parida'
Cc: ccielab@groupstudy.com
Subject: RE: dlsw explorerQ depth
That did it! Thanks, Sovan!
-----Original Message-----
From: sovan parida [mailto:sovanp@yahoo.com]
Sent: Monday, June 17, 2002 5:18 AM
To: George Spahl
Cc: ccielab@groupstudy.com
Subject: Re: dlsw explorerQ depth
Hi George,
The command should be "source-bridge explorerq-depth"
Sovan.
--- George Spahl <g.spahl@insightbb.com> wrote:
> Greetings,
>
> When trying to set the explorer queue depth I get
> the following results:
>
> R2-2502B(config)#dlsw explorerQ-depth ?
>
> <10-1000> Maximum Depth of explorer queue in
> packets
>
> netbios Configure depth for Netbios control
> queue
>
> other Configure depth for Other (UI) control
> queue
>
> sna Configure depth for SNA control queue
>
>
>
> R2-2502B(config)#dlsw explorerQ-depth 100
>
> Old style DLSw Explorer Queue Depth command
> encountered.
>
> Current or Default values will be maintained.
>
> R2-2502B(config)#
>
>
>
> Is there a new style command that should be used
> instead? Couldn't find
> any documentation on this. This is 12.1 (15).
>
> Thanks,
>
> George
>
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:37 GMT-3