From: kris.keen@xxxxxxxxxx
Date: Tue Jun 18 2002 - 00:50:35 GMT-3
debug ppp authentication and show us your config
-----------------------------------------------------------------
Kris Keen - CCNP, CCDP, CNE
Network Support Specialist - Network Systems
Aon Risk Services Australia Limited
(612) 9253 7272
0404862970
E: Kris.Keen@aon.com.au
"Lance"
<Lance@advnete To: <ccielab@groupstudy.com>
ch.com> cc:
Sent by: bcc:
nobody@groupst Subject: OSPF Demand Circuit issue
s
udy.com
18/06/2002
01:14 PM
Please respond
to "Lance"
My demand circuit is bouncing up and down.
R5 is connecting to R3 via ISDN. Both routers have the command no
peer-neighbor routes entered as well as both having the ip ospf
damand-circut
command. I dont understand why it is not working. Anyone have any ideas?
Also what command do I use to show if all my routers understand the DNA
bit?
Also R5 never shows R3 as a neighbor when the ISDN line is up. R3 shows R5
as
a neighbor in the INIT state, never full ?
Any guru's out there want to tackle this one? BTW the search functionality
on
the site is down.
R5#show dialer
BRI0/0 - dialer type = ISDN
Dial String Successes Failures Last called Last status
770794XXXX 5 4 00:00:05 successful
0 incoming call(s) have been screened.
0 incoming call(s) rejected for callback.
BRI0/0:1 - dialer type = ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is data link layer up
Dial reason: ip (s=133.6.65.5, d=224.0.0.5)
Time until disconnect 115 secs
Connected to 770794xxxx (r3)
R5 is connecting to R3 via ISDN. Both routers have the command no
peer-neighbor routes entered as well as both having the ip ospf
damand-circut
command. I dont understand why it is not working. Anyone have any ideas?
Also what command do I use to show if all my routers understand the DNA
bit?
R5#
00:08:00: %ISDN-6-DISCONNECT: Interface BRI0/0:1 disconnected from
770794xxxx
r3, call lasted 120 seconds
00:08:00: %LINK-3-UPDOWN: Interface BRI0/0:1, changed state to down
R5#
00:08:00: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0/0:1, changed
state to down
R5#
00:08:10: %LINK-3-UPDOWN: Interface BRI0/0:1, changed state to up
R5#
00:08:10: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0/0:1, changed
state to up
R5#
00:08:16: %ISDN-6-CONNECT: Interface BRI0/0:1 is now connected to
770794xxxx
r3
R5#
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:36 GMT-3