From: André Bersvendsen (an-bersv@xxxxxxxxx)
Date: Sun Jun 16 2002 - 19:05:42 GMT-3
Hi,
I have configured the call manager feature in IOS for a few IP phones
in a LAB.
The router has an ISDN BRI that is used as a gateway to the ISDN network
for voice traffic.
One problem I have is that I can not get a dial-peer with VOIP to work.
The call manager in IOS dos not know the destination configured in the
dial-peer.
Another problem is that I do not know why the prefix 0 is accepted
without any specific configuration on the call manager. Is shod be the
same as a dial-peer with VOIP?
The third thing I want to know is how I can connect or peer with
another normal CCM.
This is some of the configuration I have on the router:
!
interface BRI1/0
no ip address
isdn switch-type basic-net3
isdn incoming-voice voice
!
voice-port 1/0/0
compand-type a-law
!
dial-peer voice 1 pots
incoming called-number 12345678
destination-pattern 0........
direct-inward-dial
port 1/0/0
!
tftp-server flash:SEPDEFAULT.cnf
tftp-server flash:P00203010003.bin
!
!
telephony-service
load 12SP P00203010003
ip source-address 192.168.13.1 port 2000
max-ephones 10
max-dn 10
keepalive 600
moh music-on-hold.au
time-format 24
date-format dd-mm-yy
admin-username cisco
admin-password cisco
dn-webedit
!
!
ephone-dn 1
number 1
name PHONE-1
hold-alert 15 originator
!
ephone 1
username "test1" password test
mac-address 0030.8062.ABB7
button 1:1
!
Regards,
Andri
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:34 GMT-3