From: Khurram Khani (kkhani@xxxxxxxxxxxxxxxxxx)
Date: Tue Jun 04 2002 - 19:18:46 GMT-3
Michael,
There is no "outfacing" Port 1/3 in my chassis. Blade in Slot # 1 is a
Supervisor engine with Port 1/1 and
Port 1/2 , I dont know the significance of "Port 1/3"
> Is that port a trunk or have another switch attached to it?
In my understanding , "learned" entries from other swtiches should go under
cam dynamic? Will connecting
a another switch would effect system cam in Catalyst?
Thanks
Khurram.
----- Original Message -----
From: "Michael Popovich" <m.popovich@mchsi.com>
To: "Khani, Khurram [INGO1:8851:EXCH]" <kkhani@americasm06.nt.com>
Sent: Tuesday, June 04, 2002 3:07 PM
Subject: Re: Significance of CAM SYSTEM on Cat5k
> Is that port a trunk or have another switch attached to it?
> ----- Original Message -----
> From: "Khurram Khani" <kkhani@nortelnetworks.com>
> To: <ccielab@groupstudy.com>
> Sent: Tuesday, June 04, 2002 4:53 PM
> Subject: Significance of CAM SYSTEM on Cat5k
>
>
> > Hi All,
> >
> > Question:
> >
> > I see below MACs when I do show cam system on a Cat5k. Can any one
> explain
> > the use
> > of below macs by Catalyst
> >
> > Console> (enable) show cam system
> > * = Static Entry. + = Permanent Entry. # = System Entry. R = Router
Entry.
> X =
> > Port Security Entry
> >
> > VLAN Dest MAC/Route Des Destination Ports or VCs / [Protocol Type]
> > ---- ------------------
> > ----------------------------------------------------
> > 1 01-00-0c-cc-cc-cc# 1/3
> > 1 01-00-0c-ee-ee-ee# 1/3
> > 1000 00-10-1f-94-c3-ff# 1/3
> > 1000 01-00-0c-cc-cc-cc# 1/3
> > 1000 01-00-0c-cc-cc-cd# 1/3
> > 1000 01-80-c2-00-00-00# 1/3
> > 1000 01-80-c2-00-00-01# 1/3
> > Total Matching CAM Entries Displayed = 7
> > Console> (enable)
> >
> > thanks
> > Khurram Khani.
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:24 GMT-3