From: Ng, Kim Seng David (David) (ksng@xxxxxxxxx)
Date: Tue Jun 04 2002 - 07:57:03 GMT-3
Hi group,
I have a query in Section III item (3) which reads:
"Configure the PPP link between R1 and R4 to be in OSPF Area 10. Ring 2 is in O
SPF Area 20. This link should become active only upon loss of Frame Service."
My query is related to the last sentence. The model solution provided s
olved this by configuring a "backup interface" at the R1 and R4 frame-relay int
erface respectively which points to the ppp link as the backup interface. I tri
ed pulling the R1 frame-relay interface and instead of going into active mode,
the ppp serial interface goes into down mode. I think this is because R4's ppp
interface is still in standby/down mode.
Should the solution be only have "backup interface" command on one end
only?
Thanks
David
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:23 GMT-3