From: Michael Snyder (msnyder@xxxxxxx)
Date: Thu May 30 2002 - 19:41:11 GMT-3
That's the hard way. Just put a AGS+ on the right hand side of the
stack of 2500's. You could even turn off the internal fans in the
2500's, they won't overheat next to the ags.
Seriously, I've never had a problem with stacking 2500 routers. They
have small air ducts and channels designed on the bottom of the case.
One cools the top of the next one below it. The metal case of the 2500
acts as a heat sink as long as there's some internal air movement inside
the case.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Scott Morris
Sent: Thursday, May 30, 2002 4:14 PM
To: 'cash2001'; ccielab@groupstudy.com
Subject: RE: router rack materials
A lot of people I have seen place 1/2" plywood between the routers with
a cut out section beneath the fan for ventilation...
Probably not the best in the world, but over the years I really haven't
heard complaints. Just clean off the dust every once and a while!
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
cash2001
Sent: Thursday, May 30, 2002 4:56 PM
To: ccielab@groupstudy.com
Subject: router rack materials
I recently purchased 6 routers and have them stack one on top the other.
5 are 2501's with the ventilation on the bottom. Aside from placing
them in a rack, would spacers between each router suffice for proper
ventilation? Also, where would one obtain the mini rack to hold 6
routers?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:12 GMT-3