RE: Multiple ospf process

From: GOLBERY Irčne (irene.golbery@xxxxxxxx)
Date: Tue May 28 2002 - 09:52:40 GMT-3

• Next message: David Ham: "BGP route-reflector"
• Previous message: amlendu kumar: "RE: Saudi job"
• Maybe in reply to: GOLBERY Irčne: "Multiple ospf process"
• Next in thread: alain faure: "Re: Multiple ospf process"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Thanks Oliver for your answer.
I checked your answer testing it - good

Thanks for your help.

-----Message d'origine-----
De : Oliver Boehmer [mailto:oboehmer@cisco.com]
Envoyi : mardi 28 mai 2002 13:39
@ : GOLBERY Irhne
Cc : ccielab@groupstudy.com
Objet : Re: Multiple ospf process

Hi Irene,

the rule is: Every OSPF process will chose a different RID, and the order
depends on the configuration (i.e. after a reload, IOS allocates a RID in
the order the processes are defined in the configuration). The algorithm
each process uses is the same (i.e. loopbacks first, then highest IP
address, etc.).
If you have 10 processes, but only 9 interfaces with IP addresses, the last
OSPF process fails to start.

         oli

At 11:54 28.05.2002 +0200, GOLBERY Irhne wrote:
>Hello,
>
>
>How does ospf works when there is in a routeur multiple ospf processes and
>one or multiple loopack ?
>What is the Rid choice for each ospf process ? ( What is the rule ?)
>
>Thanks for your help
>
>Irene.

• Next message: David Ham: "BGP route-reflector"
• Previous message: amlendu kumar: "RE: Saudi job"
• Maybe in reply to: GOLBERY Irčne: "Multiple ospf process"
• Next in thread: alain faure: "Re: Multiple ospf process"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:10 GMT-3