From: garry baker (fallow46@xxxxxxxxx)
Date: Sun May 26 2002 - 20:11:05 GMT-3
GUys,
I have just added some config for snapshot routing
that i have used previously and i am only getting rip
routes appearing only on the server but not the
client. WHen debugging rip i see the routes going out
of the server towards the client but no joy in the
routing table. The snapshot functionality other than
this is working fine. I have pasted the appropriate
parts of the configs and routing tables.
interface BRI2/0
ip address 10.0.0.5 255.255.255.0
encapsulation ppp
dialer map ip 10.0.0.3 broadcast 38310xxx
dialer-group 1
isdn switch-type basic-net3
snapshot server 5 dialer
10.0.0.0/24 is subnetted, 1 subnets
C 10.0.0.0 is directly connected, BRI2/0
R 133.3.0.0/16 [120/2] via 10.0.0.3, 00:04:04,
BRI2/0
133.5.0.0/24 is subnetted, 1 subnets
C 133.5.5.0 is directly connected, Loopback0
133.9.0.0/24 is subnetted, 1 subnets
C 133.9.25.0 is directly connected, Ethernet2/0
R 133.50.0.0/16 [120/2] via 10.0.0.3, 00:04:04,
BRI2/0
r5#
interface BRI0
ip address 10.0.0.3 255.255.255.0
encapsulation ppp
dialer map snapshot 2 broadcast 38325830
dialer map ip 10.0.0.5 name r5 broadcast 38325830
dialer-group 1
isdn switch-type basic-net3
snapshot client 5 8 dialer
10.0.0.0/24 is subnetted, 1 subnets
C 10.0.0.0 is directly connected, BRI0
133.3.0.0/24 is subnetted, 1 subnets
C 133.3.3.0 is directly connected, Loopback0
C 133.50.0.0/16 is directly connected, Ethernet0
r3#
Garry
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:09 GMT-3